3. How to use KidsBlock

1.Interface： Img

2.ClickImg to switch to different languages. Img

3.TapImg to select Install driver.（Note: If the driver is not installed, as shown below: Img

A.Click Next at the Device Driver Installation Wizard page. Img

B.After a while, click Finish Img

C.Then click Next Img

D.And click Finish Img

E.Then click Allow and Install Img

F.After a while，click Finish Img

G.Select Extract Img

H.Click Next Img

I.Next, click I accept this agreement and Next Img

J.Click Finish Img

K.After a while, click INSTALL Img

O.After a few seconds, when the driver is installed, just click OK Img

4.ClickImg to enter the main page, and select the control board needed. In this project, we select the kidsUno mainboard and click Connect, then it is connected. Click Go to Editor to return the code editor. IconImg will change into Img and Img will change into Img. This means the kidsUno mainboard and ports（COM）are connected.
Img Img Img Img

5.If the kidsUno mainboard is connected , but iconImg doesn’t change into Img. You need to click to connect the COM port. ClickImg. Then you will find a page pop up, showing Connected. Img Img Img Img

To disconnect the port, just clickImg and Disconnect. Img

6.The kidsUno mainboard and the COM port are connected, then Img automatically switches to Img. Img Img

Note：If you want to update libraries of KidsBlock, click then Clear cache and restart. Img

7.Imgstands for extension libraries of sensors and modules. Click Imgto enter the page of extension libraries, click a sensor or module to add. For example, if click the passive buzzer module,Not loaded will change into Loaded. Then the passive buzzerImg is added. Img Img Img

ClickImg to return to the code editor. Then you can view the passive buzzer in the blocks area. Img If you want to delete the passive buzzer, clickImg to select the passive buzzerImg. Then Loaded will change into Not loaded. Then the passive buzzer is deleted. Img Img The way of deleting other sensors or modules is as same as the passive buzzer.

8.How to open SB3 type files： The first method：Double-click SB3 type files to open them. For instance, openImg, then we need to double-click it. Img

The second method: Open Kidsblock，click file and Load from your computer，then select the SB3 type file on the computer.（for exampleImg） Img Img Img

Note：Please refer to the following link for MacOS： https://kidsblocksite.readthedocs.io/en/latest/